Operation; Operation Overview; General Instructions; Turning On The Machine - Vevor Flm-R30-Ft Mode D'emploi

4.1 Operation Overview

• ALWAYS operate this machine following all the instructions provided herein. Performance of
procedures other than those specified herein may result in property damage and personal injury.
• DO NOT use this machine for purposes not specified herein.
This section will address only some of the options and features provided by the operation
software EZCad for your reference. Before operating this machine, ensure that you have read and
understand this entire manual, and the separate EZCad software manual.

4.2 General Instructions

Turning on the Machine

1.The power cable is connected to the power supply.
2. Release the Emergency Stop button by turning it clockwise if it is locked.
3. Insert the laser key into the Scan Head and turn clockwise by 90° .
4. Press the Fiber Laser button.
5. remove the lens head cover.
6. Press the Focus switch button on the scanning head to turn on the red light guider.
The two red dots should be displayed on the working platform when the red light guider is on.
Focusing
1. Rotate the focus adjustment knob clockwise to lower the scanning head or rotate it
counterclockwise to raise the scanning head until the two red dots merge into one.
2. Make a note of the correct height on the support column's ruler for future reference.
Preparing Your Design
1. Make sure the control computer is connected to the machine via the USB cable.

Operation

26