Designated Use - Vevor Flm-R30-Ft Mode D'emploi

However, there is no guarantee that interference will not occur in a particular installation. If this
product does cause harmful interference to radio or television reception,which can be determined by
turning the product off and on, the user is encouraged to try to correct the interference by one or
more of the following measures.
· Reorient or relocate the receiving antenna.
· Increase the distance between the product and receiver.
· Connect the product to an outlet on a circuit different from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for assistance.
1.3 Designated Use And Parameters
This machine is intended for engraving signs and other consumer products on applicable
substrates. This laser can process a wide variety of metals including steel, aluminum, titanium, brass,
copper, tungsten, carbide, and chrome.（NOTE: Not applicable to wood, acrylic, leather.). The use
of this system for non-designated purposes or materials is not permitted.
The system must be operated, maintained, and repaired by the personnel familiar with the field
of use and the dangers of the machine and the material being engraved including its reflectivity,
conductivity, potential for creating harmful or combustible fumes, and so on.
Laser beams are dangerous. The manufacturer and/or seller bear(s) no responsibility and
assume(s) no liability for any improper use of this device or for any damage or injury arising from
such use. The operator is obliged to use this fiber laser marker only in accordance with its
designated use, the other instructions on the device and in its manuals, and all applicable local and
national laws and regulations.
Model
Average laser output power
Total machine power
Maximum marking range
Rotary Axis
FLM-R30-FT
30W
185W
150*150mm
No
5
FLM-R100-FT
100W
400W
175*175mm
Yes