VEVOR FLM-R30-FT Mode D'emploi page 12

Software Main Interface
This laser marking machine is controlled by the EZCad software, which must be installed on an
applicable computer to direct the laser. Some important features include the following parameters
and controls.
A. Loop Count - Specifies how many times the laser beam will repeat its path, with more loops
creating greater contrast in the marked image.
B. Speed - Specifies the speed of the beam in millimeters per second, with greater speed
creating less contrast in the marked image.
C. Power - Specifies the % of the machine's rated power that will be used, with greater power
creating greater contrast.
It is recommended to use 10%–75% of the rated power to enjoy optimal performance and
longevity for most applications.
Constantly running your laser above 80% of its rated power can significantly SHORTEN the
service life of this product.
D. Frequency - Specifies the laser's frequency in kilohertz (kHz), with higher frequency
producing a denser and darker engraving.
E. Red (F1) - Tells the laser guidance to illuminate the current laser path.
F. Mark (F2) - Fires the laser beam for testing and focus improvement.
For more instructions on the EZCad software, see the separate EZCad software manual
included in the USB flash.
10