Preparing A Control Computer; Installing The Ezcad Driver - Vevor Flm-R30-Ft Mode D'emploi

3.5 Preparing a Control Computer

1. Prepare a control computer. See the software EZCad manual in the USB for details on the
requirements for the control computer.
The control computer should not be placed more than 15 feet (4.5 m) away from the laser
marking machine to avoid possible interference with the signal in its line.
2. Prepare the applicable engraving software and its driver to operate the machine.
For your convenience, we provide a copy of the EZCad software, an EZCad manual, an EZCad
driver, and a parameter reference document for colors in the provided USB drive.
To avoid the risk of data loss, COPY AND PASTE the whole USB disk folder onto your
computer before using it.

3.6 Installing the EZCad Driver

The EZCad driver is included in the provided USB drive.
1. Turn on the laser marking machine and your computer.
2. Ensure that the USB cable is connected to the computer and laser marking machine, and insert
the provided USB drive into your computer.
3. Right click and then select Device Manager.
20