Maintenance; Maintenance Overview; Scheduled Maintenance - Vevor Flm-R30-Ft Mode D'emploi

5.1 Maintenance Overview

Unless otherwise specified, ONLY perform adjustment and maintenance of this device when
the power is turned off and the power supply has been disconnected. ONLY allow trained and
skilled professionals to modify or disassemble this device.

5.2 Scheduled Maintenance

• Keep the workroom clean and dust-free at all times.
• Ensure the device is fully powered off when not in use.
• Cover the galvanometric lens when it is not in use.
• Clean the worktable after use with a cloth wetted with greater than 75% rubbing alcohol.
NEVER clean this device with abrasive or caustic cleansers, with aerosol sprays, or with enough
water to enter any electrical component. Always allow surfaces to fully dry before further use.
• Clean the lens with cotton swab and alcohol wipe. The device can only be used after the
alcohol has evaporated.
• If removing dust from the device's vents using a vacuum, ONLY use the lowest power setting
to avoid damage to internal components.
No other servicing should be done by the operator. Do not attempt to service or replace any
parts yourself.

Maintenance

32