VEVOR FLM-R30-FT Mode D'emploi page 452

EzCad2UNI User's Manual
The arrow's direction means the marking direction. Arc means angle(above is 90). For example
set the break angle to 89 degree, when marking angle is 89 degree or bigger than 89 degree, you
can see the actually marking result below
The imaginary line is the light track when the galvo move(no laser out).
Former broken line is splitted to line segment to mark, the imaginary line is the speed up distance
or slow down distance, then with this handling that it will optimize the deep point and arc angle at
the corner.
Attention: start length and end length should not be set to too big, these two parameter should be
matched up to start TC and end TC.
If the start TC and end TC are all 0, the marking result is as below:
All rights reserved
122