Common Problems - Vevor Flm-R30-Ft Mode D'emploi

5.3 Common Problems

Problems
No Laser Output
No Engraving despite
Laser Output
Other Laser Errors
Solutions
Correct the focus by adjusting the height of the laser arm.
Correct the software parameters if they are invalid or mistaken.
Have a technician fix or establish the connection between the
laser
and the mainboard.
Have a technician fix or establish the connection between the
laser
and its power supply.
If either the fiber laser source or its power supply malfunctions,
have a technician replace them.
Confirm that the material can be safely engraved with this device.
Correct the focus by adjusting the height of the laser arm.
Adjust the software parameters to create greater intensity.
Have a technician check the control panel, scanning lens, and its
power supply. Correct any problems or replace the part.
Have a technician check the fiber laser source and the mainboard.
Correct any problems or replace the part.
33