Introduction; General Information - Vevor Flm-R30-Ft Mode D'emploi

1.1 General Information

This manual is the designated user guide for the installation, setup, safe operation, and
maintenance of your fiber laser marking machine. It is divided into several chapters covering
general information, safety instructions, installation steps, operation instructions, maintenance
instructions, and contact information.
All personnel involved in the installation, setup, operation, maintenance, and repair of this
machine should read and understand this manual, particularly its safety instructions. Substandard
performance and longevity, property damage, and personal injury may result from not knowing and
following these instructions.
Your fiber laser marker works by emitting a powerful laser beam from its fiber laser source,
sending that beam through a fiber optic cable, focusing its power through the galvanometer lens,
and using this focused light to etch designs into certain substrates.
This fiber laser marking machine uses a nanoscale fiber laser source. Its single-mode output,
good heat dissipation, high efficiency, and compact structure make it ideal for high-precision laser
marking. With typical use, this device has an average lifespan around 100,000 working hours.
However, constantly running your laser above 80% of its maximum rated power can significantly
shorten its service life. It is recommended to use settings from 10% to 75% of the maximum rated
power to enjoy optimal performance and longevity.
Note that this is a high-voltage device and, as a safety precaution, it is recommended to only
touch its components with one hand at a time during use.
Note also the active laser is invisible to the human eye and anyone in or near the working area
MUST use special protective eyewear when the laser is in use to avoid potentially permanent injury.

Introduction

3