Finishing-Up; Rotary Axis Processing - Vevor Flm-R30-Ft Mode D'emploi

Finishing-up

When you have finished engraving your design, deactivate the systems as follows:
1. Close the EZCad software and disconnect your computer.
2. Press the Fiber Laser button.
3. Turn the key counterclockwise to turn off the laser.
4. Cover the galvanometer lens.
5. For best results, disconnect your marking machine from its power supply between uses. Unplug it
or turn off its intermediary surge protector.
6. Fully clean the worktable.
4.3 Rotary Axis Processing (Be suitable for FLM-R100-FT)
Installing the Rotary Axis
1. Install the rotary axis on the worktable and place a piece of sample material on the rotary axis.
29