Publicité
EN
STEP-BY-STEP CONFIGURATION
This section explains the steps to be followed to prepare the equipment for PC control.
1.- Download and install the PC software.
Section DOWNLOADING AND INSTALLING SOFTWARE > PC SOFTWARE.
2.- If you have TAB-10-16 displays, tablets or iPads in your installation, download and install the software
on each of them.
TAB-10-16 or tablet: section SOFTWARE DOWNLOAD AND INSTALLATION > APP FOR TAB-10-16
-
OR ANDROID TABLETS.
iPad: section SOFTWARE DOWNLOAD AND INSTALLATION > APP FOR IPAD DEVICES.
-
3.- From your PC, perform the network configuration on a device-by-device basis and rename each device.
You must first configure the system matrix(es) and then the rest of the equipment in the installation.
Section PC SOFTWARE > NETWORK SETTINGS.
4.- Rename the inputs and outputs of each of the NMX matrices for easy identification.
Section PC SOFTWARE > MAIN SECTIONS > CHANNELS.
5.- Configure the input and output routing matrix.
Section PC SOFTWARE > MAIN SECTIONS > MATRIX TAB.
6.- Add to each input and output the DSP modules you want to use, and configure their parameters.
NOTE: take into account the state of system resources.
Section PC SOFTWARE > MAIN SECTIONS > DSP MODULES FOR INPUTS/OUTS.
Section PC SOFTWARE > MAIN SECTIONS > INPUTS TAB.
Section PC SOFTWARE > MAIN SECTIONS > OUTPUTS TAB.
7.- Add and configure DSP modules to the system.
Section PC SOFTWARE > MAIN SECTIONS > AUTOMIXER TAB.
Section PC SOFTWARE > MAIN SECTIONS > AEC TAB.
Section PC SOFTWARE > MAIN SECTIONS > ANS TAB.
8.- Configure presets, save a copy of each preset on your PC and rename the presets in the matrix.
Section PC SOFTWARE > MAIN SECTIONS > PRESETS.
9.- Configure the NMX-WP wall panel actions, save a copy to your PC and upload it to the panel.
Section PC SOFTWARE > WALL PANELS NMX-WP.
10.- Configure the TAB-10-16 display pages, save a copy on your PC and load it on the display.
Section PC SOFTWARE > TAB-10-16, ANDROID TABLETS AND IPADS.
NETWORK SETUP
1.- Connect the matrix and a PC via a switch or router.
2.- Double-click on the application icon to start the programme and select the matrix model you want to
configure. This selection will load the appropriate configuration panel for the specified matrix and then
bind the matrix to it. If you have more matrices, you can add them later.
NOTE: it may take a few seconds the first time you start the programme.
3.- The programme will then display the main screen.
- 4 -
Publicité
