Homelite CSP-3314 Manuel D'utilisation page 42

Homelite all in one.qxp
GB
F D E I
PROBLEM
Engine starts and runs,
but chain is not rotating.
Bar and chain running hot
and smoking.
NOTE: The carburettor adjustment needle(s) are equipped with plastic cap(s) which prevent anticlockwise rotation
from the original factory adjustment. If your product exhibits specific performance problem(s) where the
Troubleshooting Section recommends an anticlockwise needle adjustment and you have made no adjustments since
the original purchase, take the product to a factory authorised service dealer for repair. In most cases, the needed
adjustment is a simple task for the factory trained service representative.
23/12/05 16:14
P NL S DK N FIN GR HU
English
TROUBLESHOOTING
POSSIBLE CAUSE
1. Chain oil tank empty.
2. Check chain tension for
overtight condition.
3. Check for oiler function.
1. Chain brake engaged.
2. Chain tension too tight.
3. Check guide bar and
chain assembly
4. Check guide bar and
chain for damage.
Page 34
CZ RU RO PL SLO HR TR EST LT
SOLUTION
1. Oil tank should be filled every time
that fuel tank is filled.
2. Tension chain per instructions in
"Maintenance – Adjusting the Chain
Tension" earlier in this manual.
3. Run at half throttle 30 to 45 seconds.
Stop saw and check for oil dripping from
guide bar. If oil is present the chain may be
dull or bar may be damaged. If no oil is on
the guide bar, contact a Homelite service
dealer.
1. Release chain brake, refer to
"Operation – Operating Chain Brake"
earlier in this manual.
2. Tension chain per instructions in
"Maintenance – Adjusting the Chain
Tension" earlier in this manual.
3. Refer to "Maintenance – Assembling the Bar
and Chain" earlier in this manual.
4. Inspect guide bar and chain for damage.
34
LV SK BG