Aventics HF04 Mode D'emploi page 87

AVENTICS | CMS, BDC, Stand-Alone | R412008961–BDL–001–AF
Risk of uncontrolled actuator movements when the
pneumatics are switched on
Danger of injury if the system is in an undefined state
or the manual overrides are set to position "1".
O Put the system in a defined state before switching it
on.
O Set all manual overrides to position "0".
O Make sure that no personnel are within the
hazardous zone when the pressure is switched on.
1. Switch on the operating voltage.
2. Check the LED displays on the bus coupler and the
module extensions.
3. Switch on the compressed air supply.
Commissioning and operation
CAUTION
87