Applications - Aventics HF04 Mode D'emploi

AVENTICS | CMS, BDC, Stand-Alone | R412008961–BDL–001–AF
During operation
During cleaning
W
Do not put the system into operation before it is
completely assembled as well as correctly wired and
configured, and after it has been tested.
W
The device is subject to the restrictions of the IP 65
protection class. Before commissioning, make sure
that all the connection seals and plugs are leaktight to
prevent fluids or foreign bodies from penetrating the
device.
W
Make sure that there is a sufficient exchange of air or
enough cooling if your valve system has any of the
following:
– Complete equipment
– Continuously loaded solenoid valves
W
Never use solvents or aggressive detergents. Only
clean the device using a slightly damp cloth. Only use
water to do this and, if necessary, a mild detergent.
3

Applications

The module extension BDC, CMS, B-design, together with
the respective bus coupler, is used to electrically control
pneumatic valves.
Module extension with bus coupler and valve system or
as a Stand-Alone system
The module extension is intended only for operation with
a bus system (CMS B-Design, BDC B-Design) and can be
installed with a directly connected valve system (VS) or
with a Stand-Alone system end plate (SAS end plate).
59
Applications