Ambu aScope 5 Broncho 4.2 Mode D'emploi page 7

2. System description
The aScope 5 Broncho must be connected to an Ambu displaying unit. For information about
Ambu displaying units, please refer to the respective displaying units' Instructions for use.
2.1. System parts
Ambu® aScope™ 5 Broncho
– Single-use device:
aScope 5 Broncho 4.2/2.2 are not available in all countries. Please contact your local sales office.
Product name
aScope 5 Broncho 4.2/2.2
2.2. Product compatibility
The aScope 5 Broncho has been designed to be used in conjunction with:
Displaying units
– Ambu® aBox™ 2
– Ambu® aView™ 2 Advance
Note: Connector port colour and geometry on the displaying unit must match the connector colour and
geometry on the visualization device.
Endoscopic accessories
– Passive endotherapy instruments compatible with the working channel ID (such as biopsy
forceps, cytology brushes, endoscopic needles)
– Active endotherapy instruments compatible with the working channel ID (such as cryo probe)
– Accessories with standard Luer slip and/or Luer Lock (using the enclosed introducer)
*
aScope 5 Broncho 4.2/2.2 are not compatible with high frequency endotherapy instruments and laser.
Lubricants and solutions
– Sterile water
– Isotonic saline solution
– Waterbased lubricants
– Noradrenaline 0.5 mg
– Local anaesthetic gel and solutions e.g:
• 1 % lidocaine solution
• 2 % lidocaine gel
• Lidocaine 10 % aerosol spray
Airway management accessories in compliance with EN ISO 5361
– Endotracheal tubes
– Laryngeal masks
– Tracheostomy tubes
– Laryngectomy tubes
– Double-swivel catheter mounts
The aScope 5 Broncho has been evaluated to be compatible with the following endotracheal
tubes (ETT) and endotherapy instruments (EI) sizes:
aScope 5 Broncho 4.2/2.2
Part numbers:
620001000 aScope 5 Broncho 4.2/2.2
60 cm/ 23.6"
Outer diameter [mm] "
4.2 mm/0.17"
max 4.8 mm/0.19"
Minimum ETT
inner diameter
5.0 mm
Inner diameter [mm] "
2.2 mm/0.09"
EI compatible with
a working channel of
2.2 mm
*
7