Publicité
Dis T.1634007e
It is possible to copy all sensors between 2. Either from the smallest to the largest number, or
the other way around. If 2 numbers were the same, the effect is like managing the single sensor.
With
and
you choose the desired sensor number, with
and
you go from one extreme to the other. Then pressing
confirmation window will appear.
To confirm press
. To go back, press
ENTER
will return to the previous stage.
If the sensor to be copied is not configured, a window warns that the
operation is not possible.
Subsequently the screen returns to the choice of the sensor.
If this procedure is correct, a window notifies you that the operation has
been successful.
Then the screen returns to the beginning of the copy management
SENSORS-DELETE (Level 2):
This item allows you to delete a Sensor or a Group of Sensors from the configuration.
The access level and the procedure is the same as described in the previous paragraph
After choosing the sensor or sensors and confirming with
window, it will warn you that the operation was successful.
Then the screen returns to the beginning of the CANCEL management.
SENSORS-MODIFY (Level 2):
It must be used to modify an already configured sensor, press
the sensor number to be modified, excluding the non-modifiable items: MODEL., TYPE, GAS, UoM.,
F.S., AL. scroll through the parameters and choose the one you want to modify, with the same
procedure described in the paragraph
SENSORS-DETAILS:
To see the parameters of an already configured sensor, press
Once the desired Sensor number has been chosen, the items are as in
the configuration of a Sensor. You can scroll through them with
and
. Then at the end of the screen, the sensor enabling status is
also indicated. Finally, scrolling to one of the lines with the number of
the output, if it is different from zero, pressing
The items of the output details (relay) are scrolled with
the end of the screen, the silence status of the output is indicated.
LOGIC INPUT
In this submenu it is possible to manage the LOGIC INPUT (AUX), to
which it is possible to connect devices with a NO (Normally Open) or
NC (Normally Closed) contact such as Gas sensors with relay outputs,
Smoke Sensors, Buttons, etc. . . .
The access level, the procedure and the items are as
explained in the
LOGIC INPUT - ENABLE/DISABLE (Level 1):
The access level, the procedure and the items are as explained in the
ENBLE/DISABLE
section.
These two items allow you to enable or disable the LOGIC INPUT. The "disabled" status is displayed
on the main screen, next to the Input, with the symbol "
TECNOCONTROL S.r.l. - Via Miglioli, 47 20054 SEGRATE (MI) - Tel. 02. 26 92 28 90 - Fax 02. 21 33 734
CE424P User manual
. Each time it is pressed, it
CONFIGURE PRECONFIGURED SENSOR.
SENSORS
section.
the
ENTER
the
on the relevant item. Then choose
ENTER
on the relevant item.
ENTER
THRESHOLD_1 :
OUTPUT_1 N.
THRESHOLD_2 :
USCITA_2 N. :
displays the details.
THRESHOLD_3 :
OUTPUT_3 N.
and
. At
INGRESSO
1-ENABLE
2 DISABLE
3 CONFIGURE
4 COPY
5 DELETE
6 MODIFY
7 DETAILS
".
Pag. 27/52
CONFIRM ?
YES = ENTER
NO = ESC
SENSOR
N. 1
NOT CONF.
SENSOR N. 1
COPIED
FROM N. 2
TO N. 4
COPY.
SENSOR
N. 1
DELETED
7
:
0
10
2
20
:
3
SENSORS-
Publicité
