Programming The Timer - Lancellotti Maestro Série Manuel D'utilisation

The digital clock enables the oven to be set to automatically switch on and off.
INITIAL POWER-ON AND SETTING THE TIME
When first powering on the appliance or following a power failure the display flashes. Press the
key to stop the flashing and use the
rapidly).
MANUAL USE
This function is for using the oven without any programming.
It is always possible to switch from a programmed function to "Manuale" (Manual) function, by
pressing the

PROGRAMMING THE TIMER

This function activates an audible alarm after a preset time, without interfering with the
operation of the oven.
The digital analogue clock can also be used as a timer:
•
•
•
•
358
Instructions for the user
USING AND PROGRAMMING THE DIGITAL ANALOGUE CLOCK ON ASCOT OVENS
key; choose "Manuale" if no cooking programmes are to be used.
press the key and the display will light up as shown in Fig. 1;
use the / keys to set the required time; the display will illuminate
one segment for each minute set (Fig. 2 shows a cooking time of 10
minutes).
The timer starts automatically and the symbol
a few seconds the display returns to clock function;
press to display the time remaining. When the set time is reached, an
audible alarm sounds for 7 minutes and the symbol
press the key to reset the programme.
TIMER KEY
COOKING END KEY
TIME SETTING AND RESET KEY
DECREASE KEY
INCREASE KEY
/ keys to set the time (hold down the
will stop flashing. After
will flash;
/ keys to scroll
Fig. 1
Fig. 2