Electric Power Table - Lancellotti Maestro Série Manuel D'utilisation

3.7.3 Replacing the electric cable
To replace the electric cable, it is necessary to access the terminal board. It is located on the back
of the appliance, at the top left, as shown in the figure.
To replace the cable, proceed as follows:
•
•
•
•
•
•
3.8
DEEP FRYER
2.2 kW
1
COOKER OVENS
WIDTH NO.
1.4 kW
1172 1
1172 2
1.2 kW 0.85 kW 1.9 kW 2.1 kW 0.025 kW 1.2 kW 0.5 kW 1.7 kW 0.025 kW 1.2 kW 0.85 kW 1.9 kW 0.025 kW
998 2
998 3
1.4 kW
889 1
1.2 kW 0.85 kW 1.9 kW 2.1 kW 0.025 kW
698 1
698 2
340
Instructions for the installer
open the terminal board box;
unscrew the screw A that locks the cable;
loosen the screw contacts and replace the cable
with one of the same length that corresponds to the
specifications in the table in section " 3.7.1 Electric
power cable section";
the "yellow-green" earth wire must be connected to
the terminal and must be approximately 20 mm
longer than the line cables;
the neutral "blue" wire must be connected to the
terminal marked with the letter N;
the line wire must be connected to the terminal
marked with the letter L.

Electric power table

FRY-TOP
2.4 kW
1
MAIN OVEN
1.0 kW 2.8 kW 2.5 kW 0.025 kW 1.2 kW 0.5 kW 1.7 kW 0.025 kW
1 1 1 1
1 1 1 1
1 1 1 1
1
1.0 kW 2.8 kW 2.5 kW 0.025 kW
1 1 1 1
1 1 1 1
1
STEAK GRILL
2.4 kW
1
SIDE OVEN
2
2 1 1 1
1 1 1 1
1 1 1 1
2
1
1
VITROCERAMIC
GRILL
GRIDDLE
2.5 kW 2.4 kW
1
UPPER OVEN
1
1
1 1 1 1
1.2 kW 0.85 kW 1.9 kW 0.025 kW
1 1 1
1
1
1