Fitting The Front Profile; Fitting The Splash Guard (Optional) - Lancellotti Maestro Série Manuel D'utilisation

3.4
A front profile is supplied for the Genesi series models to complement the aesthetic line.
Proceed as follows to install:
•
•
3.5
The splash guard must not be used in combination with the stainless steel splashback.
Proceed as follows to install:
•
•
Any yellowing of the steel over time, which is completely natural, in no way alters its original
characteristics. It can be removed using specific steel cleaning products.
334
Instructions for the installer

Fitting the front profile

approach profile A to the assembly seat as shown in detail in drawing 1;
fit the profile until it comes into contact with the assembly seat, pushing it downwards so that it
couples with blocks B on each end of the cooker (detailed drawing 2).

Fitting the splash guard (optional)

rest the splash guard A on the back of the surface, making sure the holes are aligned.
tighten the screws B using a Phillips screwdriver.