Gas Connection - Lancellotti Maestro Série Manuel D'utilisation

3.10 Gas connection

The appliance's setting conditions are stated on the plate on the back of the appliance.
Gas-powered devices for home use, which are not connected to a conduit for the evacuation of
combustion products, must not cause a concentration of carbon monoxide that could pose a health
risk to the persons exposed in relation to the time of exposure.
We recommend checking that the appliance is properly set up for the type of
gas distributed. The connection to the gas pipes must be made in a
workmanlike manner, in compliance with current standards that prescribe the
installation of a safety tap at the end of the pipe. The threaded ½" gas
connection pipe is located at the rear on the right hand side of the appliance.
AT
BE
CH
DE
DK
ES
FI
FR
GB
IE
IT
NL
NO
PT
SE
For butane and propane, a pressure reducer conforming to standards regulations in force should
be prepared. The seals must conform to standards regulations in force.
Once the gas has been connected, check the seal of the unions with a soap and water solution.
It is possible to connect the gas in the following ways:
•
•
•
342
Instructions for the installer
●
●
●
●
●
●
●
●
●
●
●
●
●
●
using iron or copper rigid pipe;
using uninterrupted stainless steel flexible pipe with a mechanical fitting conforming to
standards regulations in force (maximum length of extended pipe 2000 mm). The pipe should
be connected straight to the elbow of the ramp;
by inserting a flexible rubber pipe conforming to standards regulations in force. This pipe
should be coupled straight to the rubber-holder P corresponding to the gas used, and locked
with a clamp F conforming to standards regulations in force. In the latter case, check the expiry
date printed on the pipe and replace it before that date.
●
●
●
●
●
●
●