Publicité
Les langues disponibles
Les langues disponibles
Make sure that during operation of the motor there is full flow of the cooling air over the surgical field. In
absence of cooling, stop using the device and call authorised technical service assistance.
If saline solution is used as a coolant, it is necessary to first detach the handpiece, have water flow through for
at least 20 seconds to rinse the handpiece and hydro-circuit lines.
LED radiation – Do not point the ray directly toward the naked eye nor look directly into it with optical
instruments. Class 1M LED device
The manufacturer will not be held responsible regarding safety, reliability or performance of the device if:
The essential requirements for the locale, detailed in the dental unit User Manual are not respected;
The assembly, the additions, the adjustments, the calibrations and the repairs are not performed by authorised
technical service personnel;
If modifications, tampering, incorrect maintenance are performed, or incompatible and/or non-original spare
parts are used;
The device is not used in compliance with the use instructions and for the purpose for which it was
manufactured.
SYMBOLS
Symbol to call the attention to other information found in the equipment User Manual.
Symbol corresponding to "TYPE B PART APPLIED" according to IEC 60601-1.
Indicates a protection grade against direct and indirect contacts
Part that may be sterilised in an autoclave
Mark of Compliance with the 93/42/EEC Directive and subsequent amendments made – (ECC
Directive 2007/47).
Symbol for disposal pursuant to the 2002/95/EC, 2002/96/EC, 2003/108/EC Directives.
CONNECTION TO THE POWER SUPPLY CABLE
The ablator must be coupled completely into its own electrically powered hose by simple pressure.
It is necessary to make sure that the coupling surfaces are clean and dry.
Avoid disconnection of the ablator from the hose while it is operational.
All manuals and user guides at all-guides.com
31/01/2011 - 97050183-03-GB - 67
Publicité
