Applications - Aventics INTERBUS S Mode D'emploi

During assembly
During commissioning
During operation
During cleaning
AVENTICS | INTERBUS S | R412005743–BDL–001–AD
The warranty only applies to the delivered configuration. The
W
warranty will not apply if the system is incorrectly assembled.
Always make sure the relevant system component is not
W
under pressure or voltage before assembly or disassembly.
Ensure that the system is prevented from power restoration
during assembly work.
Ground the modules and valve system. Observe the
W
following standards when installing the system:
– DIN EN 50178, VDE 0160 classification
– VDE 0100.
Installation may only be performed in a voltage-free and
W
pressure-free state and only by a qualified technician. In
order to avoid accidents caused by dangerous movements
of the actuators, electrical commissioning may only be
carried out in a pressure-free state.
Do not put the system into operation before it is completely
W
assembled as well as correctly wired and configured, and
after it has been tested.
The device is subject to the restrictions of the IP65
W
protection class.
Make sure that there is a sufficient exchange of air or
W
enough cooling if your valve system has any of the following:
– Full equipment status
– Continuously loaded solenoid coils
Never use solvents or strong detergents. Only clean the
W
device using a slightly damp cloth. Only use water and, if
necessary, a mild detergent.
3

Applications

The bus coupler is used to control valves via the INTERBUS S
field bus system. Input/output modules allow electrical input
and output signals to be output via the valve system's bus
connection.
The bus coupler is designed for use as a slave only on an
INTERBUS S bus system in accordance with EN 50170 Part 2.
63
Applications