Publicité
Les langues disponibles
Les langues disponibles
SYSTem:TIME <hour>, <minute>, <second>
SYSTem:TIME?
Sets the time for the instrument's real-time clock. Use SYSTem:DATE to set the date.
Parameter
<hour> 0 to 23
<minute> 0 to 59
<second> 0 to 60
Set instrument time to 20:15:30 (8:15:30 PM):
SYST:TIME 20,15,30
The real-time clock is used for Mass Memory (MMEMory) system file time stamps.
l
The real-time clock is battery-backed and retains the date and time when power is off.
l
The date and time are not affected by
l
The real-time clock does not adjust itself for time zone changes or daylight savings time. Be sure to
l
set the date and time when you first receive your instrument.
SYSTem:UPTime?
Returns the amount of time that the instrument has been running since the last power-on.
Parameter
(none)
Return time that the instrument has been running:
SYST:UPT?
Typically used to verify that the instrument is warmed up sufficiently before calibration.
l
The numbers returned indicate days, hours, minutes, and seconds, respectively.
l
SYSTem:VERSion?
Returns the version of SCPI (Standard Commands for Programmable Instruments) that the instrument
complies with. There is no front panel equivalent. See
guage
for details.
Parameter Typical Return
(none)
1994.0
Return the SCPI version:
SYST:VERS?
Keysight Truevolt Series Operating and Service Guide
Typical Return
20,15,30.000
*RST
or SYSTem:PRESet.
Typical Return
+8,+2,+13,+50
SCPI Programming Reference
Introduction to the Introduction to the SCPI Lan-
403
Publicité
