Keysight Truevolt Serie Mode D'emploi page 214

CALCulate:LIMit:{LOWer|UPPer}[:DATA] {<value>|MIN|MAX|DEF}
CALCulate:LIMit:{LOWer|UPPer}[:DATA]? [{MIN|MAX|DEF}]
Sets an upper or lower limit.
Parameter
-1.0E+15 to -1.0E-15, +1.00000000E+00
or
0.0 (default)
or
+1.0E-15 to 1.0E+15
See .
Example
You can assign a lower limit, an upper limit or both. Do not set the lower limit above the upper limit.
l
Limit crossing: If a measurement is less than the specified lower limit, bit 11 ("Lower Limit Failed") is
l
set in the Questionable Data Condition Register. A measurement greater than the specified upper
limit sets bit 12 ("Upper Limit Failed"). See
CONFigure resets both limits to 0.
l
This parameter is set to its default value after a Factory Reset (*RST) or Instrument Preset
l
(SYSTem:PRESet).
Keysight Truevolt Series Operating and Service Guide
Typical Return
STATus Subsystem Introduction
SCPI Programming Reference
for further information.
215