Publicité
Les langues disponibles
Les langues disponibles
[SENSe:]TEMPerature:SECondary {"OFF"|"CALCulate:DATA"|"SENSe:DATA"}
[SENSe:]TEMPerature:SECondary?
Selects the secondary measurement function for temperature measurements.
Parameter
{"OFF"|"CALCulate:DATA"|"SENSe:DATA"}, default
"OFF"
Configure a 4-wire RTD measurement. Select the raw sensor value (ohms in this example) as the sec-
ondary measurement. Make and retrieve measurements.
CONF:TEMP FRTD,85
TEMP:SEC "SENS:DATA"
READ?;DATA2?
Typical Response: -6.95327319E-01;+9.97282173E+01
"CALCulate:DATA" - (Applies only to the 34465A and 34470A.) The measurement value before any
l
math operations are done (including NULL).
"SENSe:DATA" is the raw sensor value; resistance for thermistor/RTD, voltage and reference tem-
l
perature for thermocouple (thermocouple measurements apply to the 34465A and 34470A only).
Use
READ?
or
INITiate
l
This parameter is set to its default value after a Factory Reset (*RST) or Instrument Preset
l
(SYSTem:PRESet).
Keysight Truevolt Series Operating and Service Guide
to start the measurement.
SCPI Programming Reference
Typical Return
"CALC:DATA"
363
Publicité
