Keysight Truevolt Serie Mode D'emploi page 397

SCPI Programming Reference
SYSTem:HELP?
Returns a complete list of the instrument's SCPI commands.
Parameter Typical Return
(none) (see below)
Return the list of SCPI commands:
SYST:HELP?
The query returns Definite Length Block Data, which allows any type of data to be transmitted as a
l
series of 8-bit data bytes. The first line is a pound sign (#) followed by one digit representing the num-
ber of digits in the decimal integer to follow. This digit is followed by a decimal integer indicating the
number of data bytes to follow, followed by the first New Line. (For example, "#47947" in the first line
means that there are 7947 data bytes to follow.) The rest of the block has one command per line,
each terminated by a New Line character (ASCII character 10).
The beginning of a returned list is shown below. Note that the actual contents may vary, depending
on the firmware revision:
#48085
:ABORt/nquery/
:CALibration:ADC?/qonly/
:CALibration:ALL?/qonly/
:CALibration:COUNt?/qonly/
:CALibration:DATA
In this list,
/nquery/ indicates a command with no query.
l
/qonly/ indicates a query with no command form.
l
All other commands consist of a command and query.
l
Syntax for each command is found in the
l
The list may include commands or queries not described in this document. These are deprecated com-
l
mands included for compatibility with older instruments.
398
Command Quick Reference.
Keysight Truevolt Series Operating and Service Guide