Publicité
Les langues disponibles
Les langues disponibles
en
USE OF THE ENGINE (Fig. 10)
Always disengage the chainbrake, pul-
ling the lever towards you before using
the accelerator.
The chain speed is regulated by the throttle trigger
(1) on the rear handgrip (2).
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine
to the chain by a centrifugal mass clutch that
prevents the chain from moving when the engine
is running at minimum speed.
CAUTION!
Do not use the machine if the chain
moves when the engine is running
idle; in this case, contact your dealer.
The correct running speed will be achieved by
pressing the throttle trigger (1) as far as possible.
7. USING THE MACHINE
Always remember that an incorrectly
used chain saw may disturb others and
have a serious impact on the environ-
ment.
To respect people and the environment:
–
Avoid using the machine in environ-
ments or at times of the day when it
may disturb others.
–
Scrupulously comply with local re-
gulations and provisions for the
disposal of waste materials after
sawing.
–
Scrupulously comply with local re-
gulations and provisions for the dis-
posal of oils, damaged parts or any
elements which have a strong im-
pact on the environment.
–
A certain amount of chain lubrica-
ting oil is released into the environ-
ment when the machine is running,
so only use biodegradable oils made
specifically for this use.
–
To avoid the risk of fire, do not leave
the machine with the engine hot on
leaves or dry grass.
40
6. HOW TO START – USE – STOP THE ENGINE
Avoid using the engine at full power for
the first 6-8 working hours.
STOPPING THE ENGINE (Fig. 10)
To stop the engine:
–
Release the throttle trigger (1) and allow the
engine to run idle for a few seconds.
–
Set the switch (4) to "STOP".
CAUTION!
When you have reduced speed to a
minimum, it may take a few seconds
for the chain to stop.
If the machine does not turn off, pull the
starter to flood and stop the engine and
immediately contact the dealer to find the
cause of the problem and request ne-
cessary repairs.
CAUTION!
Always wear suitable clothing when
using the machine. Your dealer can
provide you with all the informa-
tion on the most suitable accident
prevention devices to guarantee your
safety. Wear anti-vibration gloves. All
the above-mentioned precautions do
not however guarantee the preven-
tion of certain risks – i.e. Raynaud's
phenomenon or carpal tunnel syn-
drome. For operators who use this
machine for prolonged periods, it is-
therefore recommended to have peri-
odic check-ups of the hands and fin-
gers.
If any of the above-mentioned sym-
ptoms should appear, please contact
a physician immediately.
469601_a
Publicité
