Checking And Setting The Positions With The Oc-Top Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

8.2.7 Checking and Setting the Positions with the OC-TOP Control Panel

Checking and setting the reference position
–
Activate the mechanic level (B). See Chapter 8.2.6
–
Call up parameter 700.
–
Tap the pedal forward briefly, the machine starts and positions in the reference
position which corresponds to position "F" of the handwheel.
–
Is the handwheel in position "F"?
- If not, then the handwheel must be turned to position "F".
- Tap the pedal forward. The machine makes one revolution and
positions in the corrected position.
- The position can be corrected repeatedly.
–
If no further correction is required, exit the mechanic level or call up the next
parameter, the reference position is saved.
Checking and setting the needle position 1
–
Activate the mechanic level (B). See Chapter 8.2.6
–
Call up parameter 702 .
–
Tap the pedal forward briefly, the machine starts and positions in the needle
position 1 which corresponds to position "F" of the.
–
Is the handwheel in position "F"?
- If not, then the handwheel must be turned to position "F".
- Tap the pedal forward. The machine makes one revolution and
positions in the corrected position.
- The position can be corrected repeatedly.
–
If no further correction is required, exit the mechanic level or call up the next
parameter, the needle position 1 is saved.
Checking and setting the needle position 2
–
Activate the mechanic level (B). See Chapter 8.2.6
–
Call up parameter 703 .
–
Tap the pedal forward briefly, the machine starts and positions in the needle
position 2 which corresponds to position "C" of the.
–
Is the handwheel in position "C"?
- If not, then the handwheel must be turned to position "C".
- Tap the pedal forward. The machine makes one revolution and
positions in the corrected position.
- The position can be corrected repeatedly.
–
If no further correction is required, exit the mechanic level or call up the next
parameter, the needle position 2 is saved.
GB
67