Meanings Of The Symbols In The V810 Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

B Needle high/low
or shift function in the programming mode.
By pressing the key, a needle
movement is conducted which can be
programmed with parameter 140. See
Instructions manual, table chapter 6.16.
In the programming mode the
key has a different function. See
Chapter 7.2.6.
P Programming mode on/off
See Chapter 7.2.4 and 7.2.6
E Change-over from the parameter number to the Parameter number/Parameter value
value of the parameter.
Confirmation of the parameter value and
advance to the next parameter.
See Chapter 7.2.4 and 7.2.6
+ Increase of the value shown
in the programming mode
- Decrease of the value shown
in the programming mode

7.2.3 Meanings of the Symbols in the V810 Control Panel

Symbol
C Automatic speed activated
Only with automatically conducted
seam runs.
D Light barrier turned on
E Sewing drive turned on
F Speed limitation activated
G Bobbin thread monitor turned on
no display
Parameter number/Standard display
The displayed value is increased
The displayed value is decreased
Function Display
Symbol on
Symbol on
Symbol on
Symbol on
Symbol blinks
when the bobbin nears empty.
GB
35