Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.2.6 Changing the Parameter values in the " Technician Level " and in the
"Supplier Level" with the V810 Control Panel
Entering the code number for the "Technician Level"
–
Turn the main switch off.
–
All plugs of the controls of the sewing drive must be plugged in.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "C-0000".
–
Release the "P" key.
–
Enter code number 1907. . The numeric value of the blinking number can be
changed with the "+" or "-" key. The ">>" key advances to the next number .
–
Press the "E" key. The first parameter of the technician level "F-100." is shown.
Selecting the Parameters and Changing the Values
–
The next or the previous parameter can be called up by pressing the "+" or "-" keys.
–
The parameter can be entered with the key ">>", "+", or "-"directly.
–
Press the "E" key. The value of the selected parameter is shown.
–
The parameter value can be changed with the "+"or "-" keys..
–
Press the "E" key. The next paramater is shown
or Press the "P" key, the same parameter is shown.
Saving changed parameter values
–
Press the "P" key, the programming is ended.
–
Sew a complete seam, that is, step the pedal forward and then completely back,
the change is saved.
–
If no seam is started, the change is lost..
–
By pressing the "P" key again, one returns to the programming level.
Entering the code number for the "Supplier Level"
–
Turn the main switch off.
–
All plugs of the controls of the sewing drive must be plugged in.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "C-0000".
–
Release th "P" key.
–
Enter code number 3112. . The numeric value of the blinking number can be
changed with the "+" or "-" key. The ">>" key advances to the next number.
–
Press the "E" key. The first parameter of the supplier level "F-200" is shown.
–
Continue with " Selecting the parameters and changing the values".
GB
37
Publicité
Chapitres
Table des Matières
