Dürkopp Adler 271-140331 Instructions D'emploi page 166

7.1 Operating and Indicator Elements of the DA220C Controls
LED 1
LED 8
Key Function in the sewing mode (after main switch on)
P Calling up / exiting the programming mode
E Beginning bartack single / double / off
(indicated by LED1 and LED2)
+ End bartack single / double / off (indicated by LED3 and LED4)
- Automatic sewing foot lift at stop in the seam On/Off
(indicated by LED5)
Automatic sewing foot lift after the thread trimming On/Off
(indicated by LED6)
>> Base position of the needle in position 1 (indicated by LED7)
or in position 2 (indicated by LED8)
Key Function in the programming mode
(see Chapter 7.1.1)
P Calling up / exiting the programming mode
E Calling up a parameter value or confirming a change
+ Increase the number or value of the parameter
- Decrease the number or value of the parameter
>> Shift function
24