Dürkopp Adler 271-140331 Instructions D'emploi page 183

7 Base position of needle = down
Base position of needle = up
8 Remaining thread monitor on
The manner of operation of the remaining thread
monitor can be changed with parameter 195.
(See Efka parameter list)
9 Function key
The function of the key can be changed with
parameter F-008 (see Parameter list
Chapter 7.1.3)
1 = Softstart ON/OFF
2 = Fancy-stitch bartack ON/OFF
3 = Stroke adjustment
Manner of operation of the knee switch
or key:
"locking" = ON / "provisional" = OFF
4 = Needle cooling ON/OFF
0 Teach in or
sewing of the stored sewing program.
See Programming Instructions in the Operating Number of stitches in the seam run
Instructions
EFKA DA220C 5300
A Bartack suppression or bartack call-up
If beginning or end bartack are turned on,
pressing the key will turn off the next
bartack.
If beginning or end bartack are turned off,
pressing the key will turn on the next
bartack.
B Needle high/low
or shift function in the programming mode.
By pressing the key, a
needle movement is conducted which can be
programmed with parameter 140. See
Instructions manual, table chapter 6.16
the key has a different function. See
Chapter 7.3.8.
P Programming mode on/off
See Chapter 7.3.4 and 7.3.7
E Change-over from the parameter number to
the value of the parameter.
Confirmation of the parameter value and
advance to the next parameter.
See Chapter 7.3.4 and 7.3.7
+ Increase of the value shown
in the programming mode
- Decrease of the value shown
in the programming mode
Left arrow above the key on
Right arrow above the key on
xxxx - - I I - -
SSt ON*/OFF < -- > SSc xxx
SrS ON*/OFF
hPr ON*/OFF
nh ON*/OFF
* at ON the left arrow above
the key is turned on.
Number of the program
Number of the seam run
Number of stitches after light barrier
detection
no display
no display
Parameter number/Standard display
Parameter number/Parameter value
The displayed value is increased
The displayed value is decreased
GB
41