Meaning Of The Symbols In The V820 Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

7.3.3 Meaning of the Symbols in the V820 Control Panel

Symbol
C Abbreviation C for the code number
D Abbreviation F for the parameter number
E Program number in the Teach-in mode
F Seam run number in the Teach-in mode
G Run-lock active
H Entries via keys blocked
I Error message
J Entry of the number of stitches
in the Teach-in Mode
K Bobbin thread monitor on
L Speed limitation active
M * Right needle turned off
N Compensation stitches for light barrier
O Machine running
P Automatic speed active
Q * Left needle turned off
* These functions are not used by the class 271 - 274.
42
FunctionDisplay
Symbol on, with display of a
code number e.g. C 1907
Symbol on, with display of a
parameter number e.g. F - 111
Symbol on, with display of a
program number of a
sewing program
Symbol on, with display of a
seam run number of a
sewing program
Symbol blinks with run-lock activated
Symbol on, when the entry
via the keys is blocked.
Symbol on. (Error list see
Chapter 7.1.8)
Symbol on, with display of the
number of stitches in a seam run
Symbol blinks by a
bobbin nearing empty
Only by machines with a
bobbin thread monitor.
Symbol on, when one of the possible
speed limitations is activated.
Symbol on, when the right
needle bar is turned off.
Only by machines with automatic
turning-off of the needle bars.
Symbol on
Symbol on
Symbol on, when, in a sewing
program, a seam run is conducted
automatically with constant speed.
Symbol on, when the left
needle bar is turned off.
Only by machines with automatic
turning-off of the needle bars.