Displaying And Changing The Number Of Bartack Stitches At The Da40Ms02 Controls - Dürkopp Adler 271-140331 Instructions D'emploi

8.1.3 Displaying and Changing the Number of Bartack Stitches at the DA40MS02
Controls
Prerequisites:
–
The mains switch is turned on.
–
The pedal is in base position.
–
Sewing is not taking place.
–
The display mode 1 is turned on (see Chapter 8.1.2).
Display:
Display mode 1: Number of bartack stitches
NumberMeaning
1 Number of forward stitches in the beginning bartack
3 Number of reverse stitches in the beginning bartack
5 Number of reverse stitches in the end bartack
7 Number of forward stitches in the end bartack
8 Current programming level
Programming:
–
Press the C>> or C<< key, a number blinks.
–
Press the V+ key, the value of the blinking number is increased.
–
Press the V- key, the value of the blinking number is decreased.
–
Press the C>> or C<< key until the number to be changed blinks.
–
Press the V+ or V- key until the desired value is set.
–
Press the M+ or M- key, the blinking is ended, the change thus saved.
Change via:
V+ or V- key
V+ or V- key
V+ or V- key
V+ or V- key
Chapter 8.1.7,
8.1.8, 8.1.9
GB
51