V810 Control Panel (Optional Equipment); Operating And Indicator Elements At The V810 Control Panel; Functions Of The Keys At The V 810 Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

7.2 V810 Control Panel (Optional Equipment)

7.2.1 Operating and Indicator Elements at the V810 Control Panel

7.2.2 Functions of the Keys at the V 810 Control Panel

It is possible to turn functions on or off by briefly pressing keys at the control panel.
The functions are only then in effect on the machine if the corresponding devices
(e.g. solenoidal or electropneumatic sewing foot lift) are present.
Key Function Display
1 Double beginning bartack on
Beginning bartack off
Single beginning bartack on
2 Double end bartack on
End bartack off
Single end bartack on
3 Auto. foot lift at stop in the seam on
Auto. foot lift at stop in the seam off
Auto. foot lift after thread trimming on
Auto. foot lift after thread trimming off
4 Base position of needle = down
Base position of needle = up
A Bartack suppression or bartack call-up
If beginning or end bartack are turned on,
pressing the key will turn off the next
bartack.
If beginning or end bartack are turned off,
pressing the key will turn on the next
bartack.
34
Right arrow above the key on
Both arrows off
Left arrow above the key on
Right arrow above the key on
Both arrows off
Left arrow above the key on
Left arrow above the key on
Left arrow above the key off
Right arrow above the key on
Right arrow above the key off
Left arrow above the key on
Right arrow above the key on
no display