Changing The Direction Of Rotation At The Da40Ms02 Controls - Dürkopp Adler 271-140331 Instructions D'emploi

Checking and setting the needle position 1
–
Activate the mechanic level (B). See Chapter 8.1.8
–
Call up parameter 702 .
–
Tap the pedal forward briefly, the machine starts and positions in the needle
position 1 which corresponds to position "F" of the.
–
Is the handwheel in position "F"?
- If not, then the handwheel must be turned to position "F".
- Tap the pedal forward. The machine makes one revolution and
positions in the corrected position.
- The position can be corrected repeatedly.
–
If no further correction is required, exit the mechanic level or call up the next
parameter, the needle position 1 is saved.
Checking and setting the needle position 2
–
Activate the mechanic level (B). See Chapter 8.1.8
–
Call up parameter 703.
–
Tap the pedal forward briefly, the machine starts and positions in the needle
position 2 which corresponds to position "C" of the.
–
Is the handwheel in position "C"?
- If not, then the handwheel must be turned to position "C".
- Tap the pedal forward. The machine makes one revolution and
positions in the corrected position.
- The position can be corrected repeatedly.
–
If no further correction is required, exit the mechanic level or call up the next
parameter, the needle position 2 is saved.

8.1.11 Changing the Direction of Rotation at the DA40MS02 Controls

–
Activate the special level (C) (see Chapter 8.1.7).
–
Change the parameter value <800>
–
Exit the special level (C) (see Chapter 8.1.7).
58
ATTENTION!
The direction of rotation is correctly set at delivery.
ATTENTION!
All needle positions must be set again after a change in the
direction of rotation. See Chapter 8.1.10.