General Safety Instructions - Dürkopp Adler 271-140331 Instructions D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 218

General safety instructions

The non-observance of the following safety instructions can cause bodily in-
juries or damages to the machine.
1.
The machine must only be commissioned in full knowledge of the instruction
book and operated by persons with appropriate training.
2.
Before putting into service also read the safety rules and instructions of the
motor supplier.
3.
The machine must be used only for the purpose intended. Use of the machine
without the safety devices is not permitted. Observe all the relevant safety
regulations.
4.
When gauge parts are exchanged (e.g. needle, presser foot, needle plate, feed
dog and bobbin) when threading, when the workplace is left, and during
service work, the machine must be disconnected from the mains by switching
off the master switch or disconnecting the mains plug.
5.
Daily servicing work must be carried out only by appropriately trained persons.
6.
Repairs, conversion and special maintenance work must only be carried out by
technicians or persons with appropriate training.
7.
For service or repair work on pneumatic systems, disconnect the machine from
the compressed air supply system (max. 7-10 bar).
Before disconnecting, reduce the pressure of the maintenance unit.
Exceptions to this are only adjustments and functions checks made by
appropriately trained technicians.
8.
Work on the electrical equipment must be carried out only by electricians or
appropriately trained persons.
9.
Work on parts and systems under electric current is not permitted,
except as specified in regulations DIN VDE 0105.
10.
Conversion or changes to the machine must be authorized by us and made
only in adherence to all safety regulations.
11.
For repairs, only replacement parts approved by us must be used.
12.
Commissioning of the sewing head is prohibited until such time as the entire
sewing unit is found to comply with EC directives.
It is absolutely necessary to respect
the safety instructions marked by these signs.
Please note also the general safety instructions.
Danger of bodily injuries !

Publicité

Table des Matières
loading

Table des Matières