Setting Machine-Specific Parameters At The Da220C Controls; General; Autoselect; Table Of Machine-Specific Parameters For The Da220C Controls - Dürkopp Adler 271-140331 Instructions D'emploi

7.1.6 Setting Machine-specific Parameters at the DA220C controls

7.1.6.1 General

The functions of the controls of the sewing drive are determined through the program
and the settings of parameters.
At shipment of the sewing drives by the drive manufacturer the parameter values are
preset (preset values). For each class and subclass some parameters at the
"Technician Level" or also at the "Supplier Level" must be changed in order to optimally
adapt the controls to the machine. The effected parameters are listed in Table 7.1.6.3
and in the parameter sheet (see Table 7.1.6.2). The parameter sheet is found in the
accessories pack. All parameters are correctly set at shipment of the machine through
the Dürkopp Adler AG!

7.1.6.2 Autoselect

The controls "recognize", by measuring the Autoselect resistor, which is found in the
machine, which machine series is attached to them. Control functions and the preset
values of the parameters are selected via Autoselect. If the controls detect no or an
invalid Autoselect resistor, then the drive runs with only the so-called emergency run
functions in order to protect the machine against damage.
(see Operating Instructions "EFKA DA220C 5300")
Autoselect Classes
resistor
100R (100 Ohm) 271 - 272
100R (100 Ohm) 273 - 274

7.1.6.3 Table of Machine-specific Parameters for the DA220C Controls

The values of the parameters listed as follows must be altered in relation to the preset
values.
The values to be set (x) are to be found in the parameter sheet 9800 331101 PB10
or 9800 331101 PB11. (In the accessories pack of the machine).
Parameter * Designation
F-111 T Upper limit of the maximum speed
F-250 A Function module for output A **
F-251 A Output A and LED A after the
thread trimming. **
F-252 A Output A inverted? 0=No, 1=Yes **
F-255 A Function module for output B **
F-256 A Output B and LED B after the
thread trimming **
* T = Parameter at the technician level, A = Parameter at the supplier level.
** A function module is a part of the controls which controls an equipment characteristic
of the machine, e.g. the lifting and lowering of the transport roller. The controls contain
the two function modules A and B.
Each function module includes the following hardeware:
–
An output (A or B) e.g. for the switching of a solenoid valve.
Controls- Parameter sheet
sewing drive
DA220C 9800 331101 PB10
DA220C 9800 331101 PB11
271
x
GB
272 273 274
x
x x x
x
x x
x
x
31