Attaching And Connecting The Sewing Light Transformer (Optional Equipment); Connection To The Da220C Controls - Dürkopp Adler 271-140331 Instructions D'emploi

6.3 Attaching and Connecting the Sewing Light Transformer
(Optional Equipment)
–
Pull out the mains plug of the sewing machine!
–
Connect the mains connection lead of the sewing light transformer to the mains
input side on the controls. (See Data sheet 9800 331101 DAT)

6.3.1 Connection to the DA220C Controls

1 6
–
Loosen the 4 screws on the front plate of the controls.
–
Remove the front plate.
–
Push the cable from the back through the cable duct 6 into the controls.
–
Remove the black rubber grommet 1.
–
Push through the round opening of the rubber grommet with a screwdriver.
–
Guide the cable of the sewing light transformer through the resulting opening in the
rubber grommet.
–
Insert the rubber grommet again.
–
With a small screwdriver press on the terminal openings 4 and 5 to open the
terminals 2 and 3.
–
Connect the blue cable to terminal 2 and the brown cable to terminal 3.
–
Fasten the front plate with the 4 screws again.
18
ATTENTION!
The sewing light transformer is connected directly to the
mains and still carries current when the main switch is
turned off.
Work on the sewing light transformer, e.g. changing the
fuse, is only to be conducted with the mains plug pulled out.
2 3 4 5