Changing Parameter Values At The "Technician Level" And The "Supplier Level - Dürkopp Adler 271-140331 Instructions D'emploi

7.1.4 Changing Parameter Values at the "Technician Level" and the "Supplier Level"

Note!
All parameter values can be returned to the preset values through a master reset. See
Chapter 7.1.7.
Entering the code number for the technician level at the DA220C controls
–
Turn the main switch off.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "cod".
–
Release the "P" key.
–
Press the ">>" key. The display shows "000". The left number blinks.
–
Enter code no. 190. The value of the blinking number is changed with the "+" or "-"
key. The ">>" key advances to the next number.
–
Press the "E" key. The first parameter of the technician level "1.0.0." is shown.
Selecting the parameters and changing the values
–
Enter the desired parameter with the "+", "-" and ">>" keys.
(see Chapter 7.1.1.2)
–
Press the "E" key. The value of the parameter is shown.
–
The parameter value can be changed with the "+" or "-" key.
–
Press the "E" key. The next parameter is shown or press the "P" key - the same
parameter is shown.
Saving changed parameter values
–
Press the "P" key, the programming is ended.
–
Sew a complete seam, that is, step the pedal forward and then completely back,
the change is saved.
–
If no seam is started, the change is lost.
–
By pressing the "P" key again, one returns to the programming level.
28
ATTENTION!
The changing of the parameter values must be conducted
very carefully because incorrectly set drive controls can
damage the machine!