Changing Parameter Values In The "Technician Level " And The "Supplier Level" With The V820 Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

7.3.7 Changing Parameter Values in the "Technician Level " and the "Supplier
Level" with the V820 Control Panel
Entering the Code Number for the Technician Level
–
Turn the main switch off.
–
All plugs must be plugged in the controls of the sewing drive.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "C-0000".
–
Release the "P" key.
–
Enter code number 1907 with the numerical keys 0 to 9.
–
Press the "E" key. The first parameter of the technician level "F-100" is shown.
Selecting the parameters and changing the values
–
After entry of the code number the display shows the first parameter "F-100".
–
Enter the selected parameter number via the numerical keys 0 to 9.
–
Press the "E" key. The value of the selected parameter is shown.
–
The parameter value can be changed with the "+"or "-" keys..
–
Press the "E" key. The next parameter is shown or press the "P" key - the same
parameter is shown.
Saving changed parameter values
–
Press the "P" key, the programming is ended.
–
Sew a complete seam, that is, step the pedal forward and then completely back,
the change is saved.
–
If no seam is started, the change is lost.
–
By pressing the "P" key again, one returns to the programming level.
Entering the Code Number for the "Supplier Level"
–
Turn the main switch off.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "C-0000".
–
Release the "P" key.
–
Enter the code number 3112 via the numerical keys 0 to 9 .
–
Press the "E" key. The first parameter of the technician level "F-200" is shown.
–
Continue as in Chapter 7.3.7 "Selecting the Parameters and Changing the
Values".
44
ATTENTION!
The changed parameter values are only then saved to
memory, when, after exiting the programming level, a
complete seam is sewn, that is, step the pedal forward and
then completely back.
When, after exiting the programming level, the drive is
immediately shut off, the changes are lost.