Changing The Direction Of Rotation With The Oc-Top Control Panel - Dürkopp Adler 271-140331 Instructions D'emploi

8.2.8 Changing the Direction of Rotation with the OC-TOP Control Panel

Attention! The direction of rotation is correctly set at delivery .
–
Activate the special level (C) (see Chapter 8.2.6).
–
Change the parameter value <800>
–
Exit the special level (C) (see Chapter 8.2.6).
68
ATTENTION!
All needle positions must be set again after a change in the
direction of rotation. See Chapter 8.2.7.