Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8.2.11 Malfunction and Error Messages in the DA40MS Controls and
the OC-TOP Control Panel
At intervals the controls check their own operativeness and that of the drive.
Malfunctions are indicated by the LED H1 in the controls or in the display of the control
panel, e.g.
No.
Type of malfunction
1
The pedal is not in the zero position at mains ON
9
Start lock
10
The machine class was changed.
Remedy: Turn the mains switch off and on again
62
Short curcuit at 24V (32V) direct-current
63
Overload of the 24V (32V) direct-current,
Load current > 4A.
64
Mains voltage too low (90 - 150V)
65
The power electronics are not operational after
mains ON. (Mains voltage < 130V)
66
Ground contact. Motor or motor lead have a ground ERROR 66
contact in one or more phases.
67
Internal malfunction
68
a) Excess current, short curcuit in the motor or
in the motor lead
b) Overvoltage, mains voltage too high (>300V).
c) Undervoltage
70
Machine blocked, no increment impulses
come from the synchronizer at maximum
motor torque.
71
The lead of the commutation initiator is not
plugged in.
73
The motor is overloaded.
75
Internal malfunction
90
EEPROM is not present
91
EEPROM is not programmable
92
Start lock at motor run
93
EEPROM is false
100 -
Internal malfunction
117
8.2.12. Seam Programming with the OC-TOP Control Panel
5 sewing programs with 5 seam runs each can be programmed with the OC-TOP control
panel. Description see Operating Instructions MINI-STOP QE3760 Typ DA40MS.
72
OC-TOP
DA40MS
DA40MS02
ERROR 01
-
ERROR 09
-
ERROR 10
-
ERROR 62
LED H1 blinks
ERROR 63
LED H1 blinks
ERROR 64
LED H1 blinks
ERROR 65
LED H1 blinks
LED H1 blinks
ERROR 67
LED H1 blinks
ERROR 68
LED H1 blinks
ERROR 70
LED H1 blinks
ERROR 71
LED H1 blinks
ERROR 73
LED H1 blinks
ERROR 75
LED H1 blinks
ERROR 90
LED H1 blinks
ERROR 91
LED H1 blinks
ERROR 92
LED H1 blinks
ERROR 93
LED H1 blinks
ERROR ...
LED H1 blinks
Publicité
Chapitres
Table des Matières
