Machines With An Edge Trimmer - Dürkopp Adler 271-140331 Instructions D'emploi

3.2.2 Machines with an Edge Trimmer

(Classes 272-640642, 272-740642)
–
Fasten table top 12 with wood screws (B8 x 35) onto the stand.
The alignment on the stand is shown in the dimensions given in the sketch.
–
Insert the machine head support 15 into the drilled hole in the table top.
–
Insert the rubber rests 14 for the machine head into the recesses in the table top 12.
–
Insert the rest plugs 13 and push on the compression springs.
–
Screw in the drawer 11 with its mountings at the left under the table top.
–
Screw on the cable duct 10 at the back under the table top.
–
Mark the positions of the screw connections of the oil baffle 2 with a center punch
and fasten with wood screws under the table top cutout.
–
Mark the positions of the screw connections of the waste chute 16 with a center
punch and fasten with wood screws under the table top cutout.
Connect the oil baffle 2 and the waste chute with a screw.
–
Insert yarn stand 1 into the drilled hole in the table top and fasten with nuts and
washers.
Attach and align the yarn spool holder and yarn guide arm.
The yarn spool holder and yarn guide arm must lie parallel above one another.
16
GB
11