Winding The Underthread - Dürkopp Adler 271-140331 Instructions D'emploi

6.4 Winding the Underthread

–
Place the bobbin on the winder shaft 1.
–
Thread the underthread as shown in the illustration.
–
Wind the underthread clockwise onto the bobbin core.
–
Pull the thread end through the trimming clamp 2 and cut.
–
Swing the winder flap 3 against the bobbin.
–
Turn the main switch on.
–
Start the sewing sequence.
–
After reaching the set bobbin-fill quantity (see Service Instructions), the winder
turns off automatically.
16
1 2
3