Winding The Hook Thread - Dürkopp Adler 271 Manuel D'utilisation

6.4

Winding the hook thread

20
1
–
Place bobbin on bobbin winder shaft 1.
–
Thread hook thread as shown in the figure.
–
Wind the hook thread around the bobbin core in clockwise
direction.
–
Pull the thread end through the clamping plate 2 and cut off.
–
Swivel the bobbin case flap 3 against the bobbin.
–
Switch on the main switch.
–
Start the sewing procedure
–
When the set bobbin filling volume is achieved (see service
instructions), the bobbin switches off automatically.
2
3