Setting The Positions At The Da220C Controls - Dürkopp Adler 271-140331 Instructions D'emploi

Entering the code number for the supplier level at the DA220C controls
–
Turn the main switch off.
–
Press the "P" key and hold down.
–
Turn the main switch on. The display shows "Cod".
–
Release the "P" key.
–
Enter code nomber 311. The numeric value of the blinking number can be changed
with the "+" or "-" key.
The ">>" key advances to the next number .
–
Press the "E" key. The first parameter of the supplier level "2.0.0." is shown.
–
Continue as in " Selecting the Parameters and Changing the Values ".

7.1.5 Setting the Positions at the DA220C Controls

Setting the reference position
Prerequisite:
The code number for the "Technician Level" is entered. (see Chapter 7.1.4)
–
Press the "E" key. The first parameter at the technician level 1.0.0. is shown.
–
Enter the parameter 1.7.0. with the "+", "-" and ">>" keys.
–
Press the "E" key. The display shows "Sr1".
–
Press the ">>" key. The display shows "P o" (the "o" character rotates).
–
Turn the handwheel in the normal direction of rotation until the rotating character
"o" in the display disappears, then continue turning until the reference position,
= position "F" of the handwheel, is reached.
–
Press the "P" key. The reference position is saved. The current parameter number
is shown.
–
Press the "P" key, the programming at the technician level is ended.
ATTENTION!
The changed parameter values are only then saved to
memory, when, after exiting the programming level, a
complete seam is sewn, that is, step the pedal forward and
then completely back.
When, after exiting the programming level, the drive is
immediately shut off, the changes are lost.
GB
29