Attaching The Controls; Attaching The Controller; Attaching The Cable Duct; Attaching The Pedal - Dürkopp Adler 271-140331 Instructions D'emploi

1
2
3
4

5.3 Attaching the Controls

–
Attach the controls 7 with 4 screws under the table top 5.
–
Fasten the mains lead of the controls under the table top with the strain relief
clamp.

5.4 Attaching the Controller

–
Screw on angle 2 under the table top 5.
–
Screw controller 3 to the angle 2.

5.5 Attaching the Cable Duct

–
Screw on cable duct 1 under the table top 5

5.6 Attaching the Pedal

–
Fasten pedal 9 to stand brace 10.
–
For ergonomic reasons pedal 9 is to be aligned sideways as follows:
The pedal center must lie approx. under the needle.
The stand brace 10 is equipped with slots for alignment of the pedal.
–
Hang the pedal rod 8 onto the controller and the pedal 9 with the ball sockets.
–
Loosen screw 4.
–
Set the height of the pedal rod so that the released pedal has an incline of about 10°.
–
Tighten screw 4.
5
6
7
8
9
10
GB
15