Dürkopp Adler 271-140331 Instructions D'emploi page 172

Setting positions 1 and 2
Prerequisite:
The reference position is set. (see Chapter 7.1.5 "Setting the Reference Position")
Note!
Because of the preset values of the positions, a setting of the positions is normally
unnecessary. The preset values (see parameter sheet in the accessories pack)
correspond to the number of increments following the reference position (in the correct
direction of rotation). A revolution of the motor shaft is equal to a revolution of the
handwheel and corresponds to 512 increments.
The positions are:
P1E = Handwheel in position "F" = position 1.
P2E = Handwheel in position "C" = position 2.
P1A = Approx. 100 increments after P1E (important for internal functions of the controls).
P2A = Approx. 100 increments after P2E (important for internal functions of the controls).
If the positions are to be set again one proceeds as follows:
–
After entering the code number for the "Technician Level" (see Chapter 7.1.4),
press the "E" key. The first parameter at the technician level, 1.0.0., is shown.
–
Enter the parameter "1.7.1." with the "+", "-" and ">>" keys.
–
Press the "E" key. The display shows "Sr2".
–
Press the ">>" key. The display shows "P1E".
–
Turn the handwheel in the correct direction until the display changes from "P1E" to
the display of the increments. Turn the handwheel to position "F" = position 1E.
–
Press the "E" key. The display shows "P2E".
–
Turn the handwheel in the correct direction until the display changes from "P2E" to
the display of the increments. Turn the handwheel to position "C" = position 2E.
–
Press the "E" key. The display shows "P1A".
–
Turn the handwheel in the correct direction until the display changes from "P1A" to
the display of the increments. Turn the handwheel approx. 100 increments beyond
position "P1E" = position "P1A".
–
Press the "E" key. The display shows "P2A".
–
Turn the handwheel in the correct direction until the display changes from "P2A" to
the display of the increments. Turn the handwheel approx. 100 increments beyond
position "P2E" = position "P2A".
–
Press the "P" key twice. The setting of the positions is completed, the
programming level is exited.
–
Checking the positions see Chapter 6.8.
Note!
If the verification of the positions should show that e.g. the actual positions 1 and 2 "run
past" the settings by approx. the same amount, then one can move the reference
position forward by this amount.
30