Environmental Protection; Storage - Efco GST 360 Manuel D'utilisation Et D'entretien

CAUTION – If the muffler is damaged, it
must be replaced. If the muffler frequently
I
becomes blocked, this could be an indication
that the efficiency of the catalytic converter is
limited.
GB
WARNING – Do not use the chain saw if
the muffler is damaged or missing, or
F
has been altered in any way. Operating the
machine with an improperly maintained
muffler will increase the risk of fire and
D
hearing loss.
EXTRA MAINTANANCE ADVISABLE
E
It is advisable to inspect the machine by a
specialized technician at an authorized service
NL network at the end of season, if used intensively,
and every two years if with normal use.
P
WARNING! – Any maintenance operations
not specifically dealt with in this manual
must be carried out by an authorised service
GR
centre. To ensure that your chainsaw continues
to function correctly, use only ORIGINAL
REPLACEMENT PARTS.
TR
Any unauthorized changes and/or
use of non-original replacement parts
CZ
may result in serious injury or death to the
operator or third parties.
SK
TRANSPORTION
Carry the chainsaw with the engine stopped,
RUS
guide bar to the rear and chain cover on (Fig. 29).
WARNING - When transpor ting the
UK
machine on a vehicle, ensure that it is
firmly and securely fastened using straps or
belts. The machine must be transported in the
PL
horizontal position, also ensuring compliance
with applicable transport regulations for such
machines.
H
LV

9. STORAGE

EST
If the machine is to be stored for long periods:
- Drain and clean the fuel and oil tank in a well-
LT
ventilated area.
- Dispose of fuel and oil according to the rules
and respecting the environment.
RO
- To drain the tank, start the engine and wait
until the fuel is exhausted and the engine
stops (leaving fuel mixture in the carburettor
could damage the membranes).
34
- Remove, clean and spray it with protective oil
the chain and the bar.
- Thoroughly clean the air intake slots on the
starter housing, the air filter (Fig. 25) and the
cylinder fins.
- Store the blower in a dry place, preferably not
in direct contact with the ground, away from
heat sources and the tanks empty.
- The procedures for returning the machine to
service following winter storage are the same
as for starting up during everyday use
(page 26).

ENVIRONMENTAL PROTECTION

Environmental protection should be a priority of
considerable importance when using the
machine, for the benefit of both social cohesion
and the environment in which we live.
- Try not to cause any disturbance to the
surrounding area.
- Scrupulously comply with local regulations
and provisions for the disposal of oils, petrol,
batteries, filters, deteriorated parts or any
elements which have a strong impact on the
environment. This waste must not be disposed
of as normal waste, it must be separated and
taken to specified waste disposal centres
where the material will be recycled.
Demolition and disposal
When the machine reaches the end of its service
life, do not dispose of it into the environment;
instead take it to a waste disposal centre.
Most materials used in the manufacture of the
machine are recyclable; all metals (steel,
aluminium, brass) can be delivered to a normal
recycling station. For information contact your
local waste recycling service. Waste disposal must
be carried out with respect for the environment,
avoiding soil, air and water pollution.
In all cases, applicable local legislation must
be complied with.
When the machine is scrapped also the CE mark
label must be destroyed together with this
manual.