Starting - Efco GST 360 Manuel D'utilisation Et D'entretien

5. STARTING

FUELING
I
WARNING: Gasoline is an extremely
flammable fuel. Use extreme caution
GB
when handling gasoline or fuel mix. Do not
smoke or bring any fire or flame near the fuel
or the chainsaw.
F
· To reduce the risk of fire and burn injury,
D
handle fuel with care. It is highly flammable.
· Mix and store fuel in a container approved for
gasoline.
E
· Mix fuel outdoors where there are no sparks or
flames.
NL
· Select bare ground, stop engine, and allow to
cool before refueling.
· Loosen fuel cap slowly to release pressure and
P
to keep fuel from escaping around the cap.
· Tighten fuel cap securely after refueling. Unit
vibration can cause an improperly tightened
GR
fuel cap to loosen or come off and spill
quantities of fuel.
TR
· Wipe spilled fuel from the unit. Move 3 metre
away from refueling site before starting
engine.
CZ
· Never attempt to burn off spilled fuel under
any circumstances.
SK
· Do not smoke while handling fuel or while
operating the chainsaw.
· Store fuel in a cool, dry, well ventilated place.
RUS
· Never place the mitblower in a combustible
area such as dry leaves, straw, paper, etc.
· Store the unit and fuel in an area where fuel
UK
vapors cannot reach sparks or open flames
from water heaters, electric motors or switches,
PL
furnaces, etc.
· Never take the cap off the tank when the
engine is running.
H
· Never use fuel for cleaning operations.
· Take care not to get fuel on your clothing.
LV
This product is powered by a 2-cycle engine and
requires pre-mixing gasoline and 2-cycle oil.
EST
Pre-mix unleaded gasoline and 2-cycle engine oil
in a clean container approved for gasoline.
RECOMMENDED FUEL: THIS ENGINE IS
LT
CERTIFIED TO OPERATE ON UNLEADED GASOLINE
INTENDED FOR AUTOMOTIVE USE WITH AN
RO
OCTANE RATING OF 89 ([R + M] / 2) OR HIGHER.
Mix 2-cycle engine oil with gasoline according to
the instructions on the package.
We strongly recommend the use of 2% (1:50)
Oleo-Mac/Efco two cycle engine oil, which is
26
specifically formulated for all air-cooled
two-stroke engines.
The correct oil / fuel proportions shown in the
table are suitable when using the Oleo-Mac/Efco
PROSINT 2 and EUROSINT 2 or an equivalent
high-quality engine oil (JASO specification FD
or ISO specification L-EGD).
GASOLINE
ℓ
1
5
10
15
20
25
CAUTION: DO NOT USE AUTOMOTIVE OIL
OR 2-CYCLE OUTBOARD OIL.
CAUTION:
- Match your fuel purchases to your
consumption; don't buy more than you
will use in one or two months;
- Store gasoline in a tightly-closed
container in a cool, dry place.
CAUTION - For the mixture, never use a
fuel with an ethanol percentage higher
than 10%; gasohol (mixture of gasoline and
ethanol) up to 10% ethanol or E10 fuel are
acceptable.
NOTE - Prepare only the quantity of mixture
required for immediate use; do not leave fuel in
the tank or a container for a long time. Were
commend the use of the additive Emak ADDITIX
2000 code 001000972 if the mixture is to be
stored for 12 months.
Alkylate gasoline
CAUTIONS – Alkylate fuels have different
density than normal fuel. Therefore
engines, set with normal fuel, need different H
jet regulation to avoid critical issues. For this
operation it's necessary turned at a Licensed
Service Dealer.
OIL
2% - 50:1
ℓ
(cm 3 )
0,02 (20)
0,10 (100)
0,20 (200)
0,30 (300)
0,40 (400)
0,50 (500)